RGB Controller on Atmega8
Submitted by: Anton Fominykh (admin@radioparty.ru).
Added a third channel for RGB backlight tachometer associated with this channel tachometer output. If you exceed the predetermined engine speed RGB channel will blink red and the buzzer, if speed decrease color channel returned to its original state if the speed does not decrease the channel remains solid red light and the buzzer goes off. When you turn on all the settings are read from the memory. If the respective control inputs log. unit feeds smoothly switched, first the first and then the second and third. If the delay is set to smooth engagement channels are included with the appropriate delay. If you turn raised the handbrake all channels 5 times blink red. If the input is 1 log. zero first RGB channel goes off smoothly with the appropriate delay. If the input is 2 log. zero second RGB channel goes off smoothly with the appropriate delay. If the input 1 and 2 log. zero all the RGB channels in turn will go out smoothly with a proper delay. If the input is 1 log. a first unit and a third RGB channels flare smoothly with a proper delay. If the input is 2 log. a second unit and a third RGB channels flare smoothly with a proper delay. If you turn on the controller while holding down the button will turn the encoder function testing RGB LEDs. In normal mode, when you turn the encoder changes the overall brightness.
Added a third channel for RGB backlight tachometer associated with this channel tachometer output. If you exceed the predetermined engine speed RGB channel will blink red and the buzzer, if speed decrease color channel returned to its original state if the speed does not decrease the channel remains solid red light and the buzzer goes off. When you turn on all the settings are read from the memory. If the respective control inputs log. unit feeds smoothly switched, first the first and then the second and third. If the delay is set to smooth engagement channels are included with the appropriate delay. If you turn raised the handbrake all channels 5 times blink red. If the input is 1 log. zero first RGB channel goes off smoothly with the appropriate delay. If the input is 2 log. zero second RGB channel goes off smoothly with the appropriate delay. If the input 1 and 2 log. zero all the RGB channels in turn will go out smoothly with a proper delay. If the input is 1 log. a first unit and a third RGB channels flare smoothly with a proper delay. If the input is 2 log. a second unit and a third RGB channels flare smoothly with a proper delay. If you turn on the controller while holding down the button will turn the encoder function testing RGB LEDs. In normal mode, when you turn the encoder changes the overall brightness.
Discussion (0 comments)