| The world of RF amplifiers is fascinating because of the wide range of methods in use. Today, many are constructed from solid-state componen...
| The world of RF amplifiers is fascinating because of the wide range of methods in use. Today, many are constructed from solid-state componen...
| The world of RF amplifiers is fascinating because of the wide range of methods in use. Today, many are constructed from solid-state componen...
| This is a submission from Keysight. Vanchip Technologies has selected their 5G test solutions to accelerate performance validation of their...
| Elektor has a long history and a good reputation with high-end yet DIY, audio projects. This time we proudly present a new power amplifier a...
| It may not be the highest of Hi-Fi but at only 38x56 mm this low-cost discrete design is smaller and cheaper than IC modules of similar powe...
| Spectrum Instruments, specialists in PC-based test, measurement and signal generation instrumentation has announced a new range of RF pre-am...
| Decent potentiometers for setting the volume in amplifiers are still quite expensive. However, there is a cheaper alternative, and it’s bett...
| The RF sweep frequency generator (‘wobbulator’) published in the October 2008 issue of Elektor has a receiver option that allows the instrum...
| This fourth of five parts deals primarily with the wiring up of the amplifier and ends with a brief resume of its performance and specific...
| The preamplifier described is a pushpull type based on a pair of inexpensive JFETs. With a few changes to the circuit, coverage may be...