More about I2C (80)

23-11-2014 | This is an highly accurate clock & calender module as a Break-out Board (BoB). I use an RV3029-C2. C2 is a 5 mm SMD. The design is very simp...

10-12-2013 | In industrial systems applications, ground potentials can vary widely, often exceeding the tolerable range, which can interrupt communicatio...

4-06-2013 | A little circuit to try out the built-in I²C driver of the LPC810. Thanks to the Switch Matrix the I²C interface can be connected to the few...

4-06-2013 | A little circuit to try out the built-in I²C driver of the LPC810. Thanks to the Switch Matrix the I²C interface can be connected to the few...

23-02-2013 | Perhaps a project already done but i try to propose it !The clock is based on 4 TAF1317A Nixie tubes drived by a K155ID1 IC and MPSA42 trans...

5-04-2012 | This stand-alone data logger displays pressure, temperature and humidity readings generated by I²C-bus sensors on an LCD panel, and can run...

5-04-2012 | This stand-alone data logger displays pressure, temperature and humidity readings generated by I²C-bus sensors on an LCD panel, and can run...

16-08-2011 | This design provides an I2C bus connection to the PC’s serial port. From a hardware point of view this serial port version of an I2C interfa...

1-12-1999 | Until not so long ago, only 8-bit analogue-to-digital converters (ADC) offered an I²C™ interface. Unfortunately, a resolution of 256 sampl...

1-07-1999 | To avoid address conflicts, every peripheral on an I²C™ bus must have a unique address. Sometimes, however, peripherals may be assigned th...