All items tagged with Power and Design (45)

1-03-1995 | The power that can be obtained from a standard car radio amplifier operating from a 12 V car battery is 5-6 W, which (for many listeners)...

1-11-1994 | The phantom power supply enables the power required by a guitar's integral preamplifier to be conveyed via the signal cable.

1-11-1994 | In this instalment, the power Inverter will be discussed. Note that this requires the car battery to be in good condttion. since at full...

1-03-1994 | This article describes a completely updated and higher-power version of the 'Medium power a.f. amplifier' published in this magazine just...

1-12-1993 | In spite of their relatively modest T0220 case, the International Rectifier HEXFETS used in the present GO-watt-output amplifier can cope...

1-11-1993 | MOSFET output transistors should be as near-identical as possible, irrespective of whether they are complerilentary pairs or connected...

1-09-1993 | The prototype loudspeaker system is housed in a 90 cm (36 in) high enclosure, details of which are shown in this article. The drive unite...

1-05-1993 | A stabilized power supply unit with current limiting is described that not only provides but also accepts power. This property is indisp...

1-04-1993 | Most audio output measurements are concerned with the voltage delivered across the loudspeaker by the output stage. If the loudspeaker...

1-09-1992 | This transmitter was designed to provide a frequency-stable, near-fool-proof, RF power source for use in the initial design of new types of...